|
|
Build Your Online Product Catalogs?
| Product Name: |
MB-01 General Tile Adhesive
|
| Supply Ability: |
500tons/month |
| Related proudcts |
qualified material, tile adhesive, general, |
| Specifications |
wall,floor |
| Price Term: |
FOB |
| Port of loading: |
Guangzhou |
| Minimum Order |
1 ton |
| Unit Price: |
negotiation |
|
Features:
1, this product is a new type strong adhesive, applied to all kinds of ceramic tile and stone material paste
2, no need to wet the brick wall, effectively improve the efficiency
3, strong bond ability, material-reducing, much safer and firmer than the traditional cement adhesive, also can reduce the construct trash and the quantity of the wall
4, good anti-infiltration and anti-aging function
5, can be used on the uneven surface or smooth cement floor
Surface Treatment:
the substrate surface should be firm, dry and clean, no grease, no wax, and other loose materials.
Operation Process:
1, the ratio: MB general tile adhesive: water: 3.3: 1 (25kg/bag, about 7.5kg water) mixed and stirred into paste, using an electric mixer to make particle paste, put it aside for a few minutes and then a little stirring to gain the better effect
2, using tooth scraper to scrap the adhesive onto the surface evenly, control within 1m2, then push the ceramic tile above it
3, for the ceramic tile with deep ditch or stone material, expect for the surface, scrap the backside of the tile or the stone material
4, leave 1.5mm joint ***ce between two tiles, suggesting MB-MC color anti-moldy gap filler
Cautions:
1, make sure the smooth and vertical rate of the surface before operation
2, for the water low absorption ceramic tile or stone material, using with MB-03 additive or MB-05 marble tile adhesive directly (specific refer the MB-03, MB-05 product introduction)
3, finished after 24h, can be walked or fill crack
4, operating under 5℃~40�situation
5, can be used with brick crack adhesive
6, never mix the dry slurry with water and use again
7, clean the surface by little wet sponge or cloth before it dry
Technical Reference:
Coverage area(amount) Technical reference
1, coverage area differs according to the circumstance 1, adjust time: about 15min (adjust time: the effective time for the dislocation to adjust)
2, using 3*3mm tooth scraper about 1.7kg/m2 2, cool time: about 10min (cool time: the lo |
| Company: |
Guangzhou Mebong Architectural Decoration Co., Ltd.
|
| Contact: |
Mr. Joe Yuan |
| Address: |
Room 1205, No. 102, Longkouxi Road, Tianhe District |
| Postcode: |
510630 |
| Tel: |
86-20-87537068 |
| Fax: |
86-20-87537118-2000 |
| E-mail: |
|
|
|
|
Home
